Section: 0MQ Manual (3)
Return to Main Contents
zmq_sendmsg - send a message part on a socket
int zmq_sendmsg (void *socket, zmq_msg_t *msg, int flags);
The zmq_sendmsg() function shall queue the message referenced by the msg argument to be sent to the socket referenced by the socket argument. The flags argument is a combination of the flags defined below:
For socket types (DEALER, PUSH) that block when there are no available peers (or all peers have full high-water mark), specifies that the operation should be performed in non-blocking mode. If the message cannot be queued on the
function shall fail with
set to EAGAIN.
Specifies that the message being sent is a multi-part message, and that further message parts are to follow. Refer to the section regarding multi-part messages below for a detailed description.
The zmq_msg_t structure passed to zmq_sendmsg() is nullified during the call. If you want to send the same message to multiple sockets you have to copy it using (e.g. using zmq_msg_copy()).
A successful invocation of zmq_sendmsg() does not indicate that the message has been transmitted to the network, only that it has been queued on the socket and 0MQ has assumed responsibility for the message.
this API method is deprecated in favor of zmq_msg_send(3).
A 0MQ message is composed of 1 or more message parts. Each message part is an independent zmq_msg_t in its own right. 0MQ ensures atomic delivery of messages: peers shall receive either all message parts of a message or none at all. The total number of message parts is unlimited except by available memory.
An application that sends multi-part messages must use the ZMQ_SNDMORE flag when sending each message part except the final one.
The zmq_sendmsg() function shall return number of bytes in the message if successful. Otherwise it shall return -1 and set errno to one of the values defined below.
Non-blocking mode was requested and the message cannot be sent at the moment.
operation is not supported by this socket type.
operation cannot be performed on this socket at the moment due to the socket not being in the appropriate state. This error may occur with socket types that switch between several states, such as ZMQ_REP. See the
for more information.
associated with the specified
The operation was interrupted by delivery of a signal before the message was sent.
The message cannot be routed.
Filling in a message and sending it to a socket.
/* Create a new message, allocating 6 bytes for message content */
int rc = zmq_msg_init_size (&msg, 6);
assert (rc == 0);
/* Fill in message content with 'AAAAAA' */
memset (zmq_msg_data (&msg), 'A', 6);
/* Send the message to the socket */
rc = zmq_sendmsg (socket, &msg, 0);
assert (rc == 6);
Sending a multi-part message.
/* Send a multi-part message consisting of three parts to socket */
rc = zmq_sendmsg (socket, &part1, ZMQ_SNDMORE);
rc = zmq_sendmsg (socket, &part2, ZMQ_SNDMORE);
/* Final part; no more parts to follow */
rc = zmq_sendmsg (socket, &part3, 0);
zmq_recv(3) zmq_socket(7) zmq(7)
This page was written by the 0MQ community. To make a change please read the 0MQ Contribution Policy at m[blue]http://www.zeromq.org/docs:contributingm.
- Multi-part messages
- RETURN VALUE
- SEE ALSO