systemd-analyze time prints the time spent in the kernel before userspace has been reached, the time spent in the initial RAM disk (initrd) before normal system userspace has been reached, and the time normal system userspace took to initialize. Note that these measurements simply measure the time passed up to the point where all system services have been spawned, but not necessarily until they fully finished initialization or the disk is idle.
systemd-analyze blame prints a list of all running units, ordered by the time they took to initialize. This information may be used to optimize boot-up times. Note that the output might be misleading as the initialization of one service might be slow simply because it waits for the initialization of another service to complete.
systemd-analyze critical-chain [UNIT...] prints a tree of the time-critical chain of units (for each of the specified UNITs or for the default target otherwise). The time after the unit is active or started is printed after the "@" character. The time the unit takes to start is printed after the "+" character. Note that the output might be misleading as the initialization of one service might depend on socket activation and because of the parallel execution of units.
systemd-analyze plot prints an SVG graphic detailing which system services have been started at what time, highlighting the time they spent on initialization.
systemd-analyze dot generates textual dependency graph description in dot format for further processing with the GraphViz dot(1) tool. Use a command line like systemd-analyze dot | dot -Tsvg > systemd.svg to generate a graphical dependency tree. Unless --order or --require is passed, the generated graph will show both ordering and requirement dependencies. Optional pattern globbing style specifications (e.g. *.target) may be given at the end. A unit dependency is included in the graph if any of these patterns match either the origin or destination node.
systemd-analyze dump outputs a (usually very long) human-readable serialization of the complete server state. Its format is subject to change without notice and should not be parsed by applications.
systemd-analyze set-log-level LEVEL changes the current log level of the systemd daemon to LEVEL (accepts the same values as --log-level= described in systemd(1)).
The following options are understood:
This plots all dependencies of any unit whose name starts with "avahi-daemon.":
$ systemd-analyze dot 'avahi-daemon.*' | dot -Tsvg > avahi.svg $ eog avahi.svg
This plots the dependencies between all known target units:
systemd-analyze dot --to-pattern='*.target' --from-pattern='*.target' | dot -Tsvg > targets.svg $ eog targets.svg